OUR EXPERTISE

Provide wide range of engineering services in Oil & Gas Industry for Downstream, Midstream and Upstream, Renewable Energy Sector, Industrial, Power Plant, Floaters and Subsea.

Engineering Consultancy

MIE-Energy offers the following multi-disciplinary engineering consultancy which covers Feasibility Studies, Conceptual Engineering, Front End Engineering Design (FEED), Detail Engineering Design, Drafting Services, as-Built Exercise, Shop Drawing and Follow on Engineering, Decommisioning Engineering(EPCM) for both new project development(Greenfield) or brownfield modification.

PROCESS

  • Process System Simulation
  • PFDs, UFDs and P & IDs Development
  • PSFS / USFS, SAFE Chart and Cause & Effect Matrix Development
  • Process Relief, Flare/Venting Study
  • HAC Preparation
  • Facilitate Topside Dynamic Simulation / Transient Analysis
  • Pipeline Steady State Hydraulic Simulation / Pipeline Transient Analysis
  • Start-Up Commission & Operating Procedure Manual
  • System Design and Sizing
  • Process Receiving and Separation
  • Condensate Dewatering Produced
  • Produced Water Treatment
  • Compression System
  • Gas Dehydration
  • Acid Gas Removal System
  • Facilities De-Bottlenecking / Adequacy Check
  • Seawater Injection System
  • Chemical Injection System
  • HAZOP

MECHANICAL / PIPING

  • Rotating & Static Equipment Design and Sizing
  • Preparation of Specifications and TBE / VDI / VDR
  • Equipment Layouts and Elevations
  • Safety Escape Route and Safety Appliances Drawings
  • 3D PDMS Modelling and Piping Design using PDMS, SP3D etc.
  • Pipe Stress Analysis and Pipe Supports Selection (Static & Dynamic)
  • Material Handling Study
  • HVAC System Design
  • Piping and Equipment Weight Estimate
  • Consolidated MTO and Costing
  • Piping General Layout, Isometric & Pipe Support Detail Drawing
  • Upgrade and Modification Work
  • HAZID

INSTRUMENTATION / TELECOMMUNICATION

  • Distributed Control System (DCS)
  • Safety Instrumented System (SIS) and Fire & Gas System (FGS)
  • SCADA and Remote Operation System
  • Programmable Logic Controller (PLC) System
  • Operator Interface (OI) & Human Machine Interface (HMI)
  • Electronic Flow Measurement / Metering / Custody Transfer
  • Specifications for Control, Monitoring & Safeguarding Instrumentation
  • Specifications for Fire & Gas Detection System
  • Specifications for Telecommunication System & Packages
  • Preparation of Functional Specifications and TBE / VDI / VDR
  • System Architectural Diagram and Block Diagrams
  • Functional Logic Diagram, Shutdown Schematic, Loop Diagram
  • 3D Fire & Gas Mapping Study
  • Alarm Rationalisation Study
  • Safety Integrity Level (SIL) Classification & Verification Study
  • Mandatory Control Framework (MCF)
  • Control System Optimization Studies and Analysis
  • Data Communications System & Networking for SCADA
  • Telecommunication Design – Microwave, Fibre Optic, Ratio, etc
  • Path Propagation and Coverage Studies
  • Instrument Power / Air Consumption Report, Valves / Orifice / Thermowell / Level Sizing
  • Consolidated MTO and Costing (CAPEX & OPEX)

ELECTRICAL

  • Electrical System Design, Sizing and Calculation
  • Preparation of Functional Specifications, TRP, Datasheet and TBE / VDI / VDR
  • Electrical Power Generation and Distribution System (HV and LV)
  • Load Simulation and Power System Analysis
  • Load List Analysis & Adequacy Check
  • Electrical Power System, i.e: Short Circuit, Motor Starting, Load Flow, Transient, Harmonic, Relay Coordination and Arc Flash study
  • Electrical Layouts (lighting, cable routing, cable tray & equipment)
  • Earthing System and Layout Design
  • Navigation Aid System Design
  • Electrical typical installation details and shop drawings
  • AC / DC UPS System Design
  • Consolidated MTO, Cost and Budgetary

CIVIL / STRUCTURAL / ARCHITECTURAL

  • Topsides Design Analysis
  • In-service (inplace)
  • Pre-service (loadout , transportation , lifting)
  • Substructure Design Analysis
  • In-service (inplace , dynamic , fatigue)
  • Pre-service (loadout , transportation , lifting , floatation & upending , launch, on-bottom)
  • Boat impact (USFOS/SACS)
  • Pushover (USFOS/SACS)
  • Miscellaneous Design
  • Service Platform, Joint Details , Drop Object study, Deck Extension, Monorail , Mudwalll support, Equipment Support, Wave slam, Pile Driveability , VIV , Clamp , Spreader Bar , Bolting Connection etc
  • Living Quarters Design + Helideck
  • Weight Control
  • Reinforced Concrete for High Rise/Low Rise Building and Tank Design
  • Roof Truss and Staircase Design
  • Pad footing, Driven Pile and Pile Cap
  • Civil Infrastructure and Culvert Design
  • Pipe rack Design
  • Substation Design
  • Tank Farm Design & Effluent Tank Design
  • Bund Wall Design
  • Underground Oily Surface Water
  • Consolidated MTO and Costing
  • Upgrade and Modification Work for Onshore and Offshore
  • Shop drawing and Constructability Sequence

PIPELINE

  • Techno-Economic Studies
  • Pipeline Material Option Study Report
  • Pipeline CDBM Report
  • Pipeline Design Basis Report
  • Pipeline Wall  Thickness Report
  • Pipeline Route Selection Report
  • Pipeline Route Finalization Report
  • Pipeline On-Bottom Stability Analysis Report
  • Pipeline Dynamic On-bottom Stability
  • Pipeline Bottom Roughness
  • Pipeline End Expansion Analysis
  • Pipeline Spanning Analysis
  • Pipeline Crossing
  • Upheaval and Lateral Buckling
  • Intervention and Mitigation for Buckling
  • Pipeline Crossing Design
  • Pipeline Expansion Spool Design
  • Riser or I/J Tube Design Report
  • Riser Clamp Design
  • Pipelin Cathodic Protection Design
  • Pipeline and Riser External Corrosion Protection Report
  • External Impact and Clashing Report
  • Pipelay & Tow Installation Engineering
  • Pipeline, Tie-in Spool and Riser Installation Feasibility Study & Laying Analysis
  • Shore Approaches
  • Pipeline Hydrotest, Pre-Commissioning and Commissioning Manual
  • Pipeline Pigging, Inspection, Maintenance and Emergency Manual
  • Pipeline Material Take-off
  • Pipeline Material Specifications
  • Pipeline and Riser Engineering Drawings
TOP